0
RESEARCH PAPERS

Turbulent Shear Flows Over a Step Change in Surface Roughness

[+] Author and Article Information
W. H. Schofield

Aeronautical Research Laboratories, Department of Defense, Fishermen’s Bend, Victoria, Australia

J. Fluids Eng 103(2), 344-351 (Jun 01, 1981) (8 pages) doi:10.1115/1.3241744 History: Received March 26, 1979; Online October 26, 2009

Abstract

A large body of data now exists on the response of turbulent shear flows to sudden or step changes in surface roughness. Authors have used a variety of methods to reduce and present the data; thus a consistent description of these flows has not yet been presented. This paper presents all available data reduced in a uniform way. As there are extremely few Reynolds stress measurements within this large body of data, the analyses presented here are necessarily based on mean velocity profiles. It is shown that the growth rate of the new internal layer for all types of flow both with and without pressure gradient can be described in terms of a single length scale associated with the new wall condition. It is also shown that all mean velocity profiles after a step change in roughness display semi-logarithmic distributions. However, in the region immediately downstream of a step the constant of proportionality (the von Karman constant) has values different from the usual equilibrium value of 0.41. The differences appear to be large with values for the constant ranging between about 0.2 to 0.8.

Copyright © 1981 by ASME
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In