0
RESEARCH PAPERS

Studies on Two-Dimensional Curved Nonbuoyant Jets in Cross Flow

[+] Author and Article Information
H. Haniu

Department of Mechanical Engineering, Kitami Institute of Technology, Hokkaido, Japan

B. R. Ramaprian

Department of Mechanical and Materials Engineering, Washington State University, Pullman, Wash.

J. Fluids Eng 111(1), 78-86 (Mar 01, 1989) (9 pages) doi:10.1115/1.3243603 History: Received June 17, 1987; Online October 26, 2009

Abstract

An experimental study of two-dimensional, curved, heated (but essentially non-buoyant) jets is reported. The experiments were conducted in a hydraulic flume in which a curved jet was produced by injecting a plane jet of slightly heated water vertically upwards in to a small cross flow. The data presented include mean and turbulent flow properties obtained from the measurement of instantaneous velocity and temperature, using two-component Laser Doppler Anemometry (LDA) and microresistance thermometry. The measurements extended over the near-to-intermediate field, namely, y/D < 60, where y is the distance along the flume and D is the width of the jet at the exit. The study has demonstrated the stabilizing effects of streamline curvature in the inner (lower) portion and the destabilizing effects of curvature and the coflowing ambient in the outer (upper) portion of the curved jet in cross flow. The quantitative effects on the mean and turbulent properties are presented and discussed in this paper.

Copyright © 1989 by ASME
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In