Livingood, J. N. B., and Hrycak, P., 1973, “Impingement heat transfer from turbulent air stream jets to flat plates: A Literature Survey,” NASA TM X-2778.

Webb,
B. W., and Ma,
C. F., 1995, “Single-phase liquid jet impingement heat transfer,” Adv. Heat Transfer, 26, pp. 105–217.

Behnia,
M., Parneix,
S., and Durbin,
P. A., 1998, “Prediction of heat transfer in an axisymmetric turbulent jet impinging on a flat plate,” Int. J. Heat Mass Transf., 41, pp. 1845–1855.

Behnia,
M., Parneix,
S., Shabany,
Y., and Durbin,
P. A., 1999, “Numerical study of turbulent heat transfer in confined and unconfined impinging jets,” Int. J. Heat Fluid Flow, 20, pp. 1–9.

Craft,
T. J., Graham,
L. J. W., and Launder,
B. E., 1993, “Impinging jets studies for turbulence model assessment-II. An examination of the performance of four turbulence models,” Int. J. Heat Mass Transf., 36, pp. 2685–2697.

Cooper,
D., Jackson,
D. C., Launder,
B. E., and Liao,
G. X., 1993, “Impinging jets studies for turbulence model assessment-I. Flow-field experiments,” Int. J. Heat Mass Transf., 36, pp. 2675–2684.

Gibson,
M. M., and Launder,
B. E., 1978, “Ground effects on pressure fluctuations in the atmospheric boundary layer,” J. Fluid Mech., 86, pp. 491–511.

Durbin,
P. A., 1996, “On the k-ε stagnation point anomaly,” J. Heat Fluid Flow, 17, pp. 89–90.

Dianat,
M., Fairweather,
M., and Jones,
W. P., 1997, “Predictions of axisymmetric and two-dimensional impinging turbulent jets,” Int. J. Heat Fluid Flow, 17, pp. 530–538.

Heyerichs,
K., and Pollard,
A., 1996, “Heat transfer in separated and impinging turbulent flows,” Int. J. Heat Mass Transf., 39, pp. 2385–2400.

Wilcox, D. C., 1993, *Turbulence Modeling for CFD*, DCW Indus. Inc, La Canada, CA.

Chen,
Q., and Modi,
V., 1999, “Mass transfer in turbulent impinging slot jets,” Int. J. Heat Mass Transf., 42, pp. 873–887.

Ashforth-Frost,
S., Jambunathan,
K., and Whitney,
C. F., 1997, “Velocity and turbulence characteristics of a semiconfined orthogonally impinging slot jet,” Exp. Therm. Fluid Sci., 14, pp. 60–67.

Wills,
J. A. B., 1962, “The correction of hot-wire readings for proximity to a solid boundary,” J. Fluid Mech., 12, pp. 388–396.

Collis,
D. C., and Williams,
M. J., 1959, “Two-dimensional convection from heated wires at low Reynolds numbers,” J. Fluid Mech., 6, pp. 357–384.

Lange,
C. F., Durst,
F., and Breuer,
M., 1999, “Correction of hot-wire measurements in the near-wall region,” Exp. Fluids, 26, pp. 475–477.

Durst,
F., Kikura,
H., Lekakis,
I., Jovanovic,
J., and Ye,
Q., 1996, “Wall shear stress determination from near-wall mean velocity data in turbulent pipe and channel flows,” Exp. Fluids, 20, pp. 417–428.

Bhatia,
J. C., Durst,
F., and Jovanovic,
J., 1982, “Correction of hot-wire ameometer measurements near walls,” J. Fluid Mech., 122, pp. 411–431.

Goldstein, R. J., 1983, *Fluid Mechanics Measurements*, Hemisphere Publishing, NY.

Khoo,
B. C., Chew,
Y. T., and Li,
G. L., 1997, “Effects of imperfect spatial resolution on turbulence measurements in the near-wall viscous sublayer region,” Exp. Fluids, 22, pp. 327–335.

Moffat,
R. J., 1982, “Contribution to the theory of single-sample uncertainty analysis,” ASME J. Fluids Eng., 104, pp. 250–260.

Moffat,
R. J., 1988, “Describing the uncertainties in experimental results,” Exp. Therm. Fluid Sci., 1, pp. 3–17.

Kline,
S. J., 1985, “The purpose of uncertainty analysis,” ASME J. Fluids Eng., 107, pp. 153–160.

Ligrani,
M. P., and Bradshaw,
P., 1987, “Spatial resolution and measurement of turbulence in the viscous sublayer using subminiature hot-wire probes,” Exp. Fluids, 5, pp. 407–417.

Ligrani,
M. P., and Bradshaw,
P., 1987, “Subminiature hot-wire sensors: development and use,” Journal of Physics, 20, pp. 323–332.

Kamemoto,
K., 1974, “Investigation of turbulence jets over logarithmic spiral surface (2nd Report, Properties of flow near wall),” Bull. JSME, 17, No. 105, pp. 343–350.

Bradshaw, P., and Gee, M. T., 1960, “Turbulent wall jets with and without an external stream,” Aeronautical Research Council-R. & M., Great Britain, 3252.

Wygnanski,
I., Katz,
Y., and Horev,
E., 1992, “On the applicability of various scaling laws to the turbulent wall jet,” J. Fluid Mech., 234, pp. 669–690.

Ligrani, M. P., 1988, “Structure of the turbulence boundary layers,” *Aerodynamics and Compressible Flows, Encyclopedia of Fluid Mechanics*, N. Cheremisinoff, ed., Vol. 8, Gulf Publishing, Houston, pp. 111–189.

Chalupa, R., Chen, M., Modi, V., and West, A. C., 2000, “High Schmidt mass transfer in a turbulent impingement slot jet,” submitted to *International Journal of Heat and Mass Transfer*.

Gardon,
R., and Akfirat,
J. C., 1996, “Heat transfer characteristics of impinging two-dimensional air jets,” ASME J. Heat Transfer, 108, pp. 101–108.