The Influence of Nitrogen and Certain Other Elements on the Creep-Rupture Properties of Wholly Austenitic Type 304 Steel

[+] Author and Article Information
P. D. Goodell

Department of Metallurgical Engineering, University of Michigan

T. M. Cullen

Combustion Engineering, Inc., Chattanooga, Tenn.

J. W. Freeman

Department of Metallurgical Engineering, University of Michigan, Ann Arbor, Mich.

J. Basic Eng 89(3), 517-524 (Sep 01, 1967) (8 pages) doi:10.1115/1.3609652 History: Received January 06, 1967; Online November 03, 2011


Experimental heats of Type 304 steel, compositionally balanced to be wholly austenitic and thus simulate the material used to produce seamless superheater tubing, were prepared to determine the influence of selected elements on the creep-rupture properties of this steel and thereby assess their possible contribution to the improvement in the elevated temperature properties which has been noted over the past years. Nitrogen is shown to increase the rupture strength at 1200 deg F of the wholly austenitic laboratory heats to a pronounced extent. Furthermore, almost the full effect of nitrogen was obtained after heat-treating at temperatures as low as 1750 deg F. Rupture strengths also increased with increasing carbon content although heat-treatment above 1750 deg F was necessary to obtain the maximum strengthening effect from the higher levels of this element. Nitrogen was a somewhat more effective strengthener than carbon, the rupture strengths correlating with (%C) + 1.25 × (%N). Small amounts of titanium, aluminum, boron, copper, and molybdenum had no or at most only minor effects on the properties. More than 0.1 percent manganese was necessary for good rupture properties but otherwise had little effect at levels up to at least 1.5 percent. Published data for commercial heats fitted the correlation developed from the laboratory heats. The generally higher level of the rupture strength data for Type 304 austenitic steel published since the early 1950’s appears to be closely related to higher levels of nitrogen. The data indicate that it is extremely important to control nitrogen content to obtain expected creep-rupture properties at 1200 deg F.

Copyright © 1967 by ASME
Your Session has timed out. Please sign back in to continue.





Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In