0
RESEARCH PAPERS

Very-Short-Time, Very-High-Temperature Creep Rupture of Type 347 Stainless Steel and Correlation of Data

[+] Author and Article Information
C. D. Lundin

Chemical and Metallurgical Engineering, The University of Tennessee, Knoxville, Tenn.

A. H. Aronson

Graham Research Center, Jones and Laughlin Steel Corporation, Pittsburgh, Pa.

L. A. Jackman

Materials Engineering Department, Rensselaer Polytechnic Institute, Troy, N. Y.

W. R. Clough

School of Mechanical Engineering, Georgia Institute of Technology, Atlanta, Ga.

J. Basic Eng 91(1), 32-38 (Mar 01, 1969) (7 pages) doi:10.1115/1.3571023 History: Received August 02, 1968; Online November 03, 2011

Abstract

Available equipment initially developed for welding research studies was used to investigate the creep-rupture behavior of AISI type 347 stainless steel in a very-high-temperature range from 62 to 86 percent of the solidus. Stress applications from 900 to 28,000 psi gave rupture times from a fraction of a second to several hundred seconds with thousandfold variations of minimum creep rate. Results could be presented by conventional means. Data scatter on a Monkman-Grant plot was typical. Correlation and extrapolation procedures developed by Larson-Miller, Manson-Haferd, Dorn, Korchynsky, and Conrad for conventional long-time results were found to be applicable, with preference being given to the Manson-Haferd procedures.

Copyright © 1969 by ASME
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In