Evaluations of loss coefficient and entrance length in the inlet region of a channel are presented. Correlations and numerical values of these quantities are provided for Reynolds number ranging from 0.01 to 2200. The results provide an accurate benchmark for engineering design.
Issue Section:
Technical Papers
1.
Shah, R. K., and London, A. L., 1978, Advances in Heat Transfer, Laminar Flow Forced Convection in Ducts, Academic Press, New York.
2.
Sparrow
, E. M.
, and Anderson
, C. E.
, 1977
, “Effect Of Upstream Flow Processes On Hydrodynamic Development In A Duct
,” ASME J. Fluids Eng.
, 99
, pp. 556
–560
.3.
Sadri, R. M., 1997, “Channel Entrance Flow,” Ph.D. thesis, The University of Western Ontario, London, Ontario, Canada.
4.
Kays, W. M., and London, A. L., 1984, Compact Heat Exchangers, McGraw-Hill, New York.
5.
Gravesen
, P.
, Branebjerg
, J.
, and Jensen
, O. S.
, 1993
, “Microfluidic-a Review
,” J. Micromech. Microeng.
, 3
, pp. 168
–182
.6.
Zou
, Q.
, Liu
, Z.
, and Goldberg
, I. S.
, 1993
, “On Non-Axisymmetric Entry Flow At Very Low Reynolds Numbers
,” Math. Biosci.
, 113
, pp. 245
–260
.7.
Bodoia
, J. R.
, and Osterle
, J. F.
, 1961
, “Finite Difference Analysis Of Plane Poiseuille And Couette Flow Developments
,” Appl. Sci. Res.
, 10
, pp. 265
–276
.8.
Schmidt
, F. W.
, and Zeldin
, B.
, 1969
, “Laminar Flows In Inlet Sections Of Tubes And Ducts
,” American Institute of Chemical Engineers Journal
, 15
, pp. 612
–614
.9.
Han
, L. S.
, 1960
, “Hydrodynamic Entrance Lengths For Incompressible Laminar Flow In Rectangular Ducts
,” ASME J. Appl. Mech.
, 27
, pp. 403
–409
.10.
Sparrow
, E. M.
, Liu
, S. H.
, and Lundgren
, T. S.
, 1964
, “Flow Development In The Hydrodynamic Entrance Region Of Tubes And Ducts
,” Phys. Fluids
, 7
, pp. 338
–347
.11.
Schlichting
, H.
, 1934
, “Laminare Kanaleinlaufsto¨mung
,” Zeitschrift fu¨r angewandte Mathematik und Mechanik
, 14
, pp. 368
–373
.12.
Schlichting, H., 1973, Boundary Layer Theory, McGraw-Hill, New York.
13.
Collins
, M.
, and Schowalter
, W. R.
, 1962
, “Laminar Flow In The Inlet Region Of A Straight Channel
,” Phys. Fluids
, 5
, pp. 222
–228
.14.
Chen
, R. Y.
, 1973
, “Flow In The Entrance Region At Low Reynolds Numbers
,” ASME J. Fluids Eng.
, 95
, pp. 153
–158
.15.
Nguyen
, T. V.
, and Maclaine-Cross
, I. L.
, 1988
, “Incremental Pressure Drop Number In Parallel-Plate Heat Exchangers
,” ASME J. Fluids Eng.
, 110
, pp. 93
–96
.16.
Lundgren
, T. S.
, Sparrow
, E. M.
, and Starr
, J. B.
, 1964
, “Pressure Drop Due To The Entrance Region In Ducts Of Arbitrary Cross Section
,” ASME J. Basic Eng.
, 88
, pp. 620
–626
.17.
Beavers
, G. S.
, Sparrow
, E. M.
, and Magnusun
, R. A.
, 1970
, “Experiments On Hydrodynamically Developing Flow In Rectangular Ducts Of Arbitrary Aspect Ratio
,” Int. J. Heat Mass Transf.
, 13
, pp. 689
–702
.18.
Morihara
, H. K.
, and Cheng
, R. T.
, 1973
, “Numerical Solution Of The Viscous Flow In The Entrance Region Of Parallel Plates
,” J. Comput. Phys.
, 11
, pp. 550
–572
.19.
Narang
, B. S.
, and Krishnamoorthy
, G.
, 1976
, “Laminar Flow In The Entrance Region Of Parallel Plates
,” ASME J. Appl. Mech.
, 43
, pp. 186
–188
.20.
Jeffery
, G.
, 1915
, “The Two-Dimensional Steady Motion Of A Viscous Fluid
,” Philos. Mag.
, 6
, pp. 455
–465
.21.
Hamel
, G.
, 1916
, “Spiralfo¨mrige Bewegungen za¨her Flu¨ssigheiten
,” Jahresbericht der Deutschen Math. Vereinigung,
, 3
, pp. 34
–60
.22.
Atkinson
, B.
, Brocklebank
, M. P.
, Card
, C. C. H.
, and Smith
, J. M.
, 1969
, “Low Reynolds Number Developing Flows
,” American Institute of Chemical Engineers Journal,
, 15
, pp. 548
–553
.23.
Williamson
, J. W.
, 1969
, “Decay Of Symmetrical Laminar Distorted Profiles Between Flat Parallel Plates
,” ASME J. Basic Eng.
, 91
, pp. 558
–560
.24.
Rokicki
, J.
, and Floryan
, J. M.
, 1999
, “Higher-Order Unstructured Domain Decomposition Method For The Navier-Stokes Equations
,” Comput. Fluids
, 28
, pp. 87
–120
.25.
Floryan
, J. M.
, and Czechowski
, L.
, 1995
, “On The Numerical Treatment Of Corner Singularity In The Vorticity Field
,” J. Comput. Phys.
, 118
, pp. 168
–182
.26.
Moffat
, H. K.
, 1964
, “Viscous And Resistive Eddies Near A Sharp Corner
,” J. Fluid Mech.
, 18
, pp. 1
–18
.27.
Fox, R. W., McDonald, A. T., 1989, Introduction to Fluid Mechanics, Wiley, New York.
28.
McComas
, S. T.
, 1967
, “Hydrodynamic Entrance Length For Ducts Of Arbitrary Cross Section
,” ASME J. Basic Eng.
, 89
, pp. 847
–850
.29.
Emery
, A. F.
, and Chen
, C. S.
, 1968
, “An Experimental Investigation Of Possible Methods To Reduce Laminar Entry Length
,” ASME J. Basic Eng.
, 90
, pp. 134
–137
.30.
Brandt
, A.
, and Gillis
, J.
, 1966
, “Magnetohydrodynamic Flow In The Inlet Region Of A Straight Channel
,” Phys. Fluids
, 9
, pp. 690
–699
.31.
Hwang
, C. L.
, and Fan
, L. T.
, 1978
, “A Finite Difference Analysis Of Laminar Magneto-Hydrodynamic Flow In The Entrance Region Of A Flat Rectangular Duct
,” Appl. Sci. Res., Sect.
, 13
, pp. 329
–343
.Copyright © 2002
by ASME
You do not currently have access to this content.