A lumped parameter model to predict the high frequency pressure oscillations observed in a water brake dynamometer is presented. It explains how the measured low frequency variations of the torque are a consequence of the variation in amplitude of the high frequency flow oscillations. Based on this model, geometrical modifications were defined, aiming to suppress the oscillations while maintaining mechanical integrity of the device. An experimental verification demonstrated the validity of the model and showed a very stable operation of the modified dynamometer even at very low torque.

Issue Section:
Gas Turbines: Electric Utilities
Topics:
Brakes, Dynamic stability, Dynamometers, Water, Oscillations, Torque, Flow (Dynamics), Lumped parameter models, Pressure
1.
Chew, J. W., and Vaughan, C. M., 1988, “Numerical Predictions for the Flow Induced by an Enclosed Rotating Disc,” ASME Paper No. 88-GT-127.
2.
Daily
J. W.
, and
Nece
R. E.
,
1960
, “
Chamber Dimension Effects on Induced Flow and Frictional Resistance of Enclosed Rotating Disks
,”
ASME Journal of Basic Engineering
, Vol.
82
, pp.
217
–
232
.
3.
Deblon, B., 1978, “Full Load Tests of the 80-MW Gas Turbine V93.2 Using a Water Brake,” ASME Paper No. 78-GT-68.
4.
Due
H. F.
,
1966
, “
An Empirical Method for Calculating Radial Pressure Distribution on Rotating Disks
,”
ASME JOURNAL OF ENGINEERING FOR POWER
, Vol.
88
, pp.
188
–
196
.
5.
Karaskiewicz, K., 1995, “Turbulent Flow Along Enclosed Rotating Disk,” VDI Berichte No. 1186, pp. 79–90.
6.
Kurokawa
J.
, and
Sakuma
M.
,
1988
, “
Flow in a Narrow Gap Along an Enclosed Rotating Disk With Through-Flow
,”
JSME International Journal
, Series II. Vol.
31
, No.
2
, pp.
243
–
251
.
7.
Nece
R. E.
, and
Daily
J. W.
,
1960
, “
Roughness Effects on Frictional Resistance of Enclosed Rotating Disks
,”
ASME Journal of Basic Engineering
, Vol.
82
, pp.
553
–
562
.
This content is only available via PDF.
Copyright © 1998
 by The American Society of Mechanical Engineers
You do not currently have access to this content.