Two pyrometric tools for measuring soot temperature response in fuel-rich flames under unsteady inlet airflow conditions are developed. High-speed pyrometry using a high-speed color camera is used in producing soot temperature distributions, with its results compared with those of global soot temperature response measured using a multiwavelength pyrometer. For the former, the pixel red, green, and blue (RGB) values pertaining to respective bandwidths of red, green, and blue filters are used to calculate temperature and for the latter, the emission from whole flame at 660 nm, 730 nm, and 800 nm is used to measure temperature. The combustor, running on jet-A fuel, achieves unsteady inlet airflow using a siren running at frequencies of 150 and 250 Hz and with modulation levels (root mean square (RMS)) 20–50% of mean velocity. Spatiotemporal response of flame temperature measured by the high-speed camera is presented by phase-averaged with average subtracted images and by fast Fourier transform (FFT) at the modulation frequencies of inlet velocity. Simultaneous measurement of combustor inlet air velocity and flame soot temperature using the multiwavelength pyrometer is used in calculating the flame transfer function (FTF) of flame temperature response to unsteady inlet airflow. The results of global temperature and temperature fluctuation from the three-color pyrometer show qualitative agreement with the local temperature response measured by the high-speed camera. Over the range of operating conditions employed, the overall flame temperature fluctuation increases linearly with respect to the inlet velocity fluctuation. The two-dimensional map of flame temperature under unsteady combustion determined using a high-speed digital color camera shows that the local temperature fluctuation during unsteady combustion occurs over relatively small region of flame and its level is greater (∼10% to 20%) than that of overall temperature fluctuation (∼1%).
Skip Nav Destination
Article navigation
Research-Article
Spatiotemporal Distribution of Soot Temperature for Flames Using Optical Pyrometry Under Unsteady Inlet Airflow Conditions
Arda Cakmakci,
Arda Cakmakci
Combustion Research Laboratory,
School of Aerospace Systems,
University of Cincinnati,
Cincinnati, OH 45220
School of Aerospace Systems,
University of Cincinnati,
Cincinnati, OH 45220
Search for other works by this author on:
Michael Knadler,
Michael Knadler
Combustion Research Laboratory,
School of Aerospace Systems,
University of Cincinnati,
Cincinnati, OH 45220
School of Aerospace Systems,
University of Cincinnati,
Cincinnati, OH 45220
Search for other works by this author on:
Jong Guen Lee
Jong Guen Lee
Combustion Research Laboratory,
School of Aerospace Systems,
University of Cincinnati,
Cincinnati, OH 45220
e-mail: Jongguen.lee@uc.edu
School of Aerospace Systems,
University of Cincinnati,
Cincinnati, OH 45220
e-mail: Jongguen.lee@uc.edu
Search for other works by this author on:
Arda Cakmakci
Combustion Research Laboratory,
School of Aerospace Systems,
University of Cincinnati,
Cincinnati, OH 45220
School of Aerospace Systems,
University of Cincinnati,
Cincinnati, OH 45220
Michael Knadler
Combustion Research Laboratory,
School of Aerospace Systems,
University of Cincinnati,
Cincinnati, OH 45220
School of Aerospace Systems,
University of Cincinnati,
Cincinnati, OH 45220
Jong Guen Lee
Combustion Research Laboratory,
School of Aerospace Systems,
University of Cincinnati,
Cincinnati, OH 45220
e-mail: Jongguen.lee@uc.edu
School of Aerospace Systems,
University of Cincinnati,
Cincinnati, OH 45220
e-mail: Jongguen.lee@uc.edu
1Corresponding author.
Contributed by the Combustion and Fuels Committee of ASME for publication in the JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER. Manuscript received August 12, 2016; final manuscript received August 24, 2016; published online December 7, 2016. Editor: David Wisler.
J. Eng. Gas Turbines Power. May 2017, 139(5): 051502 (8 pages)
Published Online: December 7, 2016
Article history
Received:
August 12, 2016
Revised:
August 24, 2016
Citation
Cakmakci, A., Knadler, M., and Lee, J. G. (December 7, 2016). "Spatiotemporal Distribution of Soot Temperature for Flames Using Optical Pyrometry Under Unsteady Inlet Airflow Conditions." ASME. J. Eng. Gas Turbines Power. May 2017; 139(5): 051502. https://doi.org/10.1115/1.4034969
Download citation file:
Get Email Alerts
Cited By
Temperature Dependence of Aerated Turbine Lubricating Oil Degradation from a Lab-Scale Test Rig
J. Eng. Gas Turbines Power
Multi-Disciplinary Surrogate-Based Optimization of a Compressor Rotor Blade Considering Ice Impact
J. Eng. Gas Turbines Power
Experimental Investigations on Carbon Segmented Seals With Smooth and Pocketed Pads
J. Eng. Gas Turbines Power
Related Articles
Temperature Measurements of Diesel Fuel Combustion With Multicolor Pyrometry
J. Heat Transfer (May,2010)
Flame-Temperature Measurements in Internal-Combustion Engines
Trans. ASME (January,1946)
Optical Properties in the Visible of Overfire Soot in Large Buoyant Turbulent Diffusion Flames
J. Heat Transfer (August,2000)
Related Proceedings Papers
Related Chapters
The Identification of the Flame Combustion Stability by Combining Principal Component Analysis and BP Neural Network Techniques
International Conference on Mechanical Engineering and Technology (ICMET-London 2011)
Predicting the Resistance of Power Cables to Flame Propagation by Neural Networks (PSAM-0069)
Proceedings of the Eighth International Conference on Probabilistic Safety Assessment & Management (PSAM)
Later Single-Cylinder Engines
Air Engines: The History, Science, and Reality of the Perfect Engine