The partitioning of the heat flux supplied at the wall is one of the key issues that needs to be resolved if one is to model subcooled flow boiling accurately. The first step in studying wall heat flux partitioning is to account for the various heat transfer mechanisms involved and to know the location at which the onset of nucleate boiling (ONB) occurs. Active nucleation site density data is required to account for the energy carried away by the bubbles departing from the wall. Subcooled flow boiling experiments were conducted using a flat plate copper surface and a nine-rod (zircalloy-4) bundle. The location of ONB during the experiments was determined from visual observations as well as from the thermocouple output. From the data obtained it is found that the heat flux and wall superheat required for inception are dependent on flow rate, liquid subcooling, and contact angle. The existing correlations for ONB underpredict the wall superheat at ONB in most cases. A correlation for predicting the wall superheat and wall heat flux at ONB has been developed from the data obtained in this study and that reported in the literature. Experimental data are within ±30 percent of that predicted from the correlation. Active nucleation site density was determined by manually counting the individual sites in pictures obtained using a CCD camera. Correlations for nucleation site density, which are independent of flow rate and liquid subcooling, but dependent on contact angle have been developed for two ranges of wall superheat—one below 15°C and another above 15°C.

1.
Warrier, G. R., and Dhir, V. K., 1999, “Review of Experimental and Analytical Studies on Low Pressure Subcooled Flow Boiling,” Proceedings of the 5th ASME/JSME Joint Thermal Engineering Conference, Paper AJTE99-6233, CD-ROM Edition.
2.
Hsu
,
Y. Y.
,
1962
, “
On the Size Range of Active Nucleation Cavities on a Heating Surface
,”
ASME J. Heat Transfer
,
84
, pp.
207
216
.
3.
Bergles
,
A. E.
, and
Rohsenow
,
W. M.
,
1964
, “
The Determination of Forced-Convection Surface-Boiling Heat Transfer
,”
ASME J. Heat Transfer
,
1
, pp.
365
372
.
4.
Sato
,
T.
, and
Matsumara
,
H.
,
1964
, “
On the Conditions of Incipient Subcooled Boiling With Forced Convection
,”
Bull. JSME
,
7
(
26
), pp.
392
398
.
5.
Davis
,
E. J.
, and
Anderson
,
G. H.
,
1966
, “
The Incipience of Nucleate Boiling in Forced Convection Flow
,”
AIChE J.
,
12
(
4
), pp.
774
780
.
6.
Kandlikar, S. G., Mizo, V., Cartwright, M., and Ikenze, E., 1997, “Bubble Nucleation and Growth Characteristics in Subcooled Flow Boiling of Water,” National Heat Transfer Conference, ASME, HTD-342, pp. 11–18.
7.
Yin
,
S. T.
, and
Abdelmessih
,
A. H.
,
1977
, “
Prediction of Incipient Flow Boiling From Uniformly Heated Surface
,”
AIChE Symp. Ser.
,
73
(
164
), pp.
236
243
.
8.
Hino
,
R.
, and
Ueda
,
T.
,
1985
, “
Studies on Heat Transfer and Flow Characteristics in Subcooled Flow Boiling-Part I. Boiling Characteristics
,”
Int. J. Multiphase Flow
,
11
(
3
), pp.
269
281
.
9.
Bar-Cohen
,
A.
, and
Simon
,
T. W.
,
1988
, “
Wall Superheat Excursions in the Boiling Incipience of Dielectric Fluids
,”
Heat Transfer Eng.
,
9
, pp.
19
31
.
10.
You
,
S. M.
,
Simon
,
T. W.
,
Bar-Cohen
,
A.
, and
Tong
,
W.
,
1990
, “
Experimental Investigation of Nucleate Boiling Incipience with a Highly-Wetting Dielectric Fluid (R113)
,”
Int. J. Heat Mass Transf.
,
33
(
1
), pp.
105
117
.
11.
Chin, Y., 1997, “An Experimental Study of Flow Boiling in a Narrow Channel: From Convection to Nucleate Boiling,” Ph.D. thesis, University of Houston, Houston, TX.
12.
Hahne, E., Spindle, K., and Shen., N., 1990, “Incipience of Flow Boiling in Subcooled Well Wetting Fluids,” Proceedings 9th International Heat Transfer Conference, Israel, 2, pp. 69–74.
13.
Tong
,
W.
,
Bar-Cohen
,
A.
,
Simon
,
T. W.
, and
You
,
S. M.
,
1990
, “
Contact Angle Effects on Boiling Incipience of Highly Wetting Liquids
,”
Int. J. Heat Mass Transf.
,
33
(
1
), pp.
91
103
.
14.
Wang
,
C. H.
, and
Dhir
,
V. K.
,
1993
, “
Effect of Surface Wettability on Active Nucleation Site Density During Pool Boiling of Water on a Vertical Surface
,”
ASME J. Heat Transfer
,
115
, pp.
659
669
.
15.
Celata
,
G. P.
,
Cumo
,
M.
, and
Mariani
,
A.
,
1997
, “
Experimental Evaluation of the Onset of Subcooled Flow Boiling at High Liquid Velocity and Subcooling
,”
Int. J. Heat Mass Transf.
,
40
(
12
), pp.
2879
2885
.
16.
Jakob, M., 1949, Heat Transfer, Wiley, New York.
17.
Gaertner
,
R. F.
, and
Westwater
,
J. W.
,
1960
, “
Population of Active Sites in Nucleate Boiling Heat Transfer
,”
Chem. Eng. Prog., Symp. Ser.
,
56
, pp.
39
48
.
18.
Hsu, Y. Y., and Graham, R. W., 1976, Transport Processes in Boiling and Two-Phase Systems, Hemisphere Publishing Corporation, Washington DC.
19.
Sultan
,
M.
, and
Judd
,
R. L.
,
1978
, “
Spatial Distribution of Active Sites and Bubble Flux Density
,”
ASME J. Heat Transfer
,
100
, pp.
56
62
.
20.
Mikic
,
B.
, and
Rohsenow
,
W. M.
,
1969
, “
A New Correlation of Pool Boiling Data Including the Effect of Heating Surface Characteristics
,”
ASME J. Heat Transfer
,
91
, pp.
245
250
.
21.
Bier, K., Gorenflo, D., Salem, M., and Tanes, Y., 1978, “Pool Boiling Heat Transfer and Size of Active Nucleation Centers for Horizontal Plates With Different Surface Roughness,” Proceedings of 6th International Heat Transfer Conference, Toronto, 1, pp. 151–156.
22.
Cornwell, K., and Brown, R. D., 1978, “Boiling Surface Topography,” Proceedings of 6th International Heat Transfer Conference, Toronto, 1, pp. 157–161.
23.
Yang
,
S. R.
, and
Kim
,
R. H.
,
1988
, “
A Mathematical Model of Pool Boiling Nucleation Site Density in Terms of Surface Characteristics
,”
Int. J. Heat Mass Transf.
,
31
, pp.
1127
1135
.
24.
Bankoff’s
,
S. G.
,
1958
, “
Entrapment of Gas in Spreading of Liquid Over a Rough Surface
,”
AIChE J.
,
4
, pp.
24
26
.
25.
Gaertner
,
R. F.
,
1963
, “
Distribution of Active Sites in the Nucleate Boiling of Liquids
,”
Chem. Eng. Prog., Symp. Ser.
,
59
, pp.
52
61
.
26.
Kocamustafaogullari
,
G.
, and
Ishii
,
M.
,
1983
, “
Interfacial Area and Nucleation Site Density in Boiling Systems
,”
Int. J. Heat Mass Transf.
,
26
(
9
), pp.
1377
1387
.
27.
Zeng
,
L. Z.
, and
Klausner
,
J. F.
,
1993
, “
Nucleation Site Density in Forced Convection Boiling
,”
ASME J. Heat Transfer
,
115
, pp.
215
221
.
28.
Warrier, G. R., Basu, N., and Dhir, V. K., 2001, “Subcooled Boiling for Low Pressures,” Progress Report for USNRC Task Order No. 5., UCLA ENG-01-224.
You do not currently have access to this content.