Molecular dynamics simulations are performed to calculate the surface tension of bubbles formed in a metastable Lennard–Jones (LJ) argon fluid. The calculated normal and transverse pressure components are used to compute a surface tension which is compared to the surface tension computed from the Young–Laplace equation. Curvature effects on surface tension are investigated by performing various sized simulations ranging from 6912 to 256,000 LJ particles. The computed surface tension values differ depending on the calculation method for the smaller systems studied but the methods converge as the system size increases. Surface tension calculations on small bubbles may not be appropriate since the liquid farthest from the interface has yet to achieve the pressure profile of a homogeneous fluid. Density profiles, pressures, and calculated surface tensions are shown to have a strong dependence on the choice of the interaction cutoff radius. A cutoff radius of 8σ, significantly larger than that commonly used in the literature, is recommended for accurate calculations in liquid–vapor systems.
Skip Nav Destination
e-mail: cosden@seas.upenn.edu
e-mail: jrlukes@seas.upenn.edu
Article navigation
Research Papers
Effect of Cutoff Radius on the Surface Tension of Nanoscale Bubbles
Ian A. Cosden,
e-mail: cosden@seas.upenn.edu
Ian A. Cosden
Department of Mechanical Engineering and Applied Mechanics, University of Pennsylvania
, Philadelphia
, PA 19104
Search for other works by this author on:
Jennifer R. Lukes
e-mail: jrlukes@seas.upenn.edu
Jennifer R. Lukes
Department of Mechanical Engineering and Applied Mechanics, University of Pennsylvania
, Philadelphia
, PA 19104
Search for other works by this author on:
Ian A. Cosden
Department of Mechanical Engineering and Applied Mechanics, University of Pennsylvania
, Philadelphia
, PA 19104e-mail: cosden@seas.upenn.edu
Jennifer R. Lukes
Department of Mechanical Engineering and Applied Mechanics, University of Pennsylvania
, Philadelphia
, PA 19104e-mail: jrlukes@seas.upenn.edu
J. Heat Transfer. Oct 2011, 133(10): 101501 (8 pages)
Published Online: August 11, 2011
Article history
Received:
May 12, 2010
Revised:
May 3, 2011
Online:
August 11, 2011
Published:
August 11, 2011
Citation
Cosden, I. A., and Lukes, J. R. (August 11, 2011). "Effect of Cutoff Radius on the Surface Tension of Nanoscale Bubbles." ASME. J. Heat Transfer. October 2011; 133(10): 101501. https://doi.org/10.1115/1.4004167
Download citation file:
Get Email Alerts
Cited By
Related Articles
Lattice Boltzmann Simulations of CO 2 Bubble Dynamics at the Anode of a μ DMFC
J. Fuel Cell Sci. Technol (May,2006)
Planar Simulation of Bubble Growth in Film Boiling in Near-Critical Water Using a Variant of the VOF Method
J. Heat Transfer (June,2004)
A Level Set Method Coupled With a Volume of Fluid Method for Modeling of Gas-Liquid Interface in Bubbly Flow
J. Fluids Eng (August,2010)
A New Two-Phase Flow Map and Transition Boundary Accounting for Surface Tension Effects in Horizontal Miniature and Micro Tubes
J. Heat Transfer (October,2001)
Related Proceedings Papers
Related Chapters
Pin Floating on Surface of a Liquid
Case Studies in Fluid Mechanics with Sensitivities to Governing Variables
Large Eddy Simulation of a Collapsing Vapor Bubble Containing Non-Condensable Gas
Proceedings of the 10th International Symposium on Cavitation (CAV2018)
Numerical Simulation of Collapsing Vapor Bubble Clusters Close to a Rigid Wall
Proceedings of the 10th International Symposium on Cavitation (CAV2018)