... enhancement Heat recovery The coke oven gas embraces 27∼30% of heat energy supplied by the coal during its coking [ 1 ]. It is now recovered mainly using a heat exchanger in ascension pipe. Some technologies have been proposed for recovery of this enormous energy, such as the jacket technology...

... temperature on the shell side, when a step change is imposed on the liquid entering the tubes. Marnoch heat engine heat recovery power generation heat transfer heat exchanger temperature distribution Waste heat recovery has a number of significant benefits in industrial processes...

...Isak Kotcioglu; Ahmet Cansiz In this study, a cross-flow heat recovery-exchanger system operating with unmixed fluids was manufactured and tested. The thermodynamic analysis of the system was presented via determining the variations of exergy loss with Reynolds number. The analysis also included...

... 2003 cooling towers pipe flow thermal resistance heat transfer condensers (steam plant) Cooling Towers Fouling Heat Transfer Heat Recovery The two subject areas of fouling and enhancement have been developed mainly independently for many years. Watkinson 1 had attempted...

... engines flow through porous media chemically reactive flow confined flow two-phase flow Engines Heat Transfer Heat Recovery Porous Media Regenerators A regenerative Diesel engine using an in-cylinder reciprocating, porous regenerator as shown in Fig. 1 has the potential to improve...

.../frosting for extreme operating conditions. 03 Sept 1997 30 Mar 1998 05 12 2007 Condensation Heat Transfer Heat Recovery Moisture Sorption ASHRAE, 1992, Desiccant cooling and dehumidification , L. Harriman, ed., American Society of Heating, Refrigerating and Air...

...: Heat Exchangers, Heat Pipes and Thermosyphons, Heat Recovery. Associate Technical Editor: J. H. Kim. angled form, some empirical observations have appeared (Zar- ling and Haynes, 1987; Haynes et al., 1991), but there appear to have been few, if any, fundamental investigations. The purpose of this note...

..., or reduced weight and a near cubic form of the exchanger core for equal pressure drops and effectiveness. 21 December 1989 07 July 1990 23 05 2008 Augmentation and Enhancement Heat Exchangers Heat Recovery E. Van den Bulck Department of Mechanical Engineering, Katholieke...

... by the Heat Transfer Division August 24, 1989; revision received February 12, 1990. Keywords: Conduction, Heat Recovery, Modeling and Scaling. quently the thermal contact conductance, are evaluated using an electrolytic tank analog. A separate numerical analysis was developed to substantiate the analog...

... Transfer Division and presented at the 24th National Heat Transfer Conference, Pittsburgh, Pennsylvania, August 9-12, 1987. Man- uscript received bv the Heat Transfer Division June 26, 1987. Keywords: Heat Exchangers, Heat Recovery, Packed and Fluidized Beds. exist variations in the thermal loads...

... Conference, Pittsburgh, Pennsylvania, August 9-12, 1987. Manuscript received by the Heat Transfer Division September 14, 1987. Keywords: Heat Exchangers, Heat Recovery. and let us derive from it the expression for the effectiveness of a^ pure counterflow configuration, which we denote P(R, NTU). Equation (1...

.... The method is applicable to any heat exchanger for which the ε-NTU-R relationships are known. 30 September 1987 20 10 2009 Heat Exchangers Heat Recovery Thermodynamics and Second Law L. C. Witte Professor of Mechanical Engineering, University of Houston, Houston, TX 77004 Fellow ASME...

.... Contributed by the Heat Transfer Division for publication in the JOURNAL OF HEAT TRANSFER. Manuscript received by the Heat Transfer Division October 15, 1986. Keywords: Heat Exchangers, Heat Recovery, Radiation. tact radiation effect (Olalde et al., 1980). With a high fluid temperature, it would seem...