Fracture mechanics has in recent years become an independent discipline that deals with determining the conditions under which machine or structural elements attain uncontrollable failure by crack propagation. A knowledge of these conditions can assist the designer to safeguard structures against catastrophic fracture. In contrast to the conventional approach, which does not account for flaws initiated in the material by manufacturing procedures, overloads, or fatigue loadings, fracture mechanics [1] assumes that all materials contain cracks from which failure starts. This concept has been used successfully for high-strength/low-toughness materials design and for structures that exhibit brittle behavior. Obtained from laboratory specimens loaded symmetrically with respect to the crack plane is a critical stress intensity factor parameter K1c. It is a characteristic of the material commonly referred to as the fracture toughness value. When machine elements are subjected to combined loading, where symmetry does not exist, the direction of crack initiation is no longer known as an a priori. The condition of crack instability can then be predicted from the strain energy density factor S whose critical value, Sc, is related to K1c from uniaxial tension tests by the relation Sc = (1 − 2ν)K1c2/4 π μ, with ν being the Poisson’s ratio and μ the shear modulus of elasticity. Numerous numerical examples involving press fit, rotating disk, thermally stressed pipe, pressure vessel, etc., are presented to show how fracture mechanics can be used for estimating the load that a member can sustain without causing unstable fracture. The results are compared with those obtained from the conventional design approach whenever possible.
Skip Nav Destination
Article navigation
November 1976
This article was originally published in
Journal of Engineering for Industry
Research Papers
The Role of Fracture Mechanics in Design Technology
G. C. Sih
G. C. Sih
Institute of Fracture and Solid Mechanics, Lehigh University, Bethlehem, Pa.
Search for other works by this author on:
G. C. Sih
Institute of Fracture and Solid Mechanics, Lehigh University, Bethlehem, Pa.
J. Eng. Ind. Nov 1976, 98(4): 1243-1249
Published Online: November 1, 1976
Article history
Received:
July 6, 1976
Online:
July 15, 2010
Citation
Sih, G. C. (November 1, 1976). "The Role of Fracture Mechanics in Design Technology." ASME. J. Eng. Ind. November 1976; 98(4): 1243–1249. https://doi.org/10.1115/1.3439093
Download citation file:
Get Email Alerts
Cited By
A Study on the Influence of Polypropylene Melt Flow Index on Nonwoven Fibers Produced Through Hot Melt Centrifugal Spinning
J. Manuf. Sci. Eng (April 2025)
Related Articles
On the Modified Virtual Internal Bond Method
J. Appl. Mech (November,2005)
The Effective Utilization of Yield Strength
J. Eng. Ind (November,1971)
Application of Fracture Mechanics to Failure in Manatee Rib Bone
J Biomech Eng (June,2006)
A Comparative Evaluation of Fatigue and Fracture Characteristics of Structural Components of Liquefied Natural Gas Carrier Insulation System
J. Pressure Vessel Technol (April,2013)
Related Proceedings Papers
Related Chapters
Subsection NB—Class 1 Components
Companion Guide to the ASME Boiler & Pressure Vessel Codes, Volume 1 Sixth Edition
Introduction and Definitions
Handbook on Stiffness & Damping in Mechanical Design
Applications of Elastic-Plastic Fracture Mechanics in Section XI, ASME Code Evaluations
Online Companion Guide to the ASME Boiler & Pressure Vessel Codes