..., and a press-compaction-assisted binder jetting process is needed to achieve this benchmark. A green density of 1.64 ± 0.02 g/cm 3 only resulted in a density of 1.65 ± 0.03 g/cm 3 by sintering at 1050 °C, which showed that densification is not possible with sintering alone. However, infiltration with Al-6061...

... elements is employed, which allows for the densification that occurs during forming. The flow strength of individual tantalum struts is directly measured in an atomic force microscope. The numerical results show that as the hexagonal cells are elongated along the sheet length, elastic springback decreases...

... prepared under a series of sintering conditions. The contents of Si 3 N 4 powder ranging between 0 wt % and 15 wt % and the sintering temperature were varied in the experiments in order to understand the dependence of densification kinetics and changes in properties on these process parameters...

... sintering/isostatic pressed (SLS/IP). The effect of processing parameters on the densification of Cu–AISI304 parts is analyzed and then the influence of Cu on their relative densities, metallurgical structures, and mechanical performances are investigated. The results show that relative densities of Cu...