Measurements of the size effect on the nominal strength of notched specimens of fiber composite laminates are reported. Tests were conducted on graphite/epoxy crossply and quasi-isotropic laminates. The specimens were rectangular strips of widths 6.4, 12.7, 25.4 and 50.8 mm (0.25, 0.50, 1.00 and 2.00 in.) geometrically similar in two dimensions. The gage lengths were 25, 51, 102 and 203 mm (1.0, 2.0, 4.0 and 8.0 in.). One set of specimens had double-edge notches and a [0/922]s crossply layup, and another set had a single-sided edge notch and a [0/±45/90]s, quasi-isotropic layup. It has been found that there is a significant size effect on the nominal strength. It approximately agrees with the size effect law proposed by Bazˇant, according to which the curve of the logarithm of the nominal strength versus the logarithm of size represents a smooth transition from a horizontal asymptote, corresponding to the strength criterion (plastic limit analysis), to an inclined asymptote of −0.5 slope, corresponding to linear elastic fracture mechanics. Optimum fits of the test results by the size effect law are obtained, and the size effect law parameters are then used to identify the material fracture characteristics, particularly the fracture energy and the effective length of the fracture process zone. Finally, the R-curves are also identified on the basis of the maximum load data. The results show that in design situations with notches or large initial traction-free cracks the size effect on the nominal strength of fiber composite laminates must be taken into account.

Issue Section:
Technical Papers
Topics:
Composite materials, Fracture (Materials), Laminates, Size effect, Fibers, Design, Dimensions, Epoxy adhesives, Epoxy resins, Fracture mechanics, Gages, Graphite, Stress, Strips, Traction
1.
ACI Committee 446, 1992, “State-of-Art-Report on Fracture Mechanics of Concrete: Concepts, Models and Determination of Material Properties,” Fracture Mechanics of Concrete Structures, by Z. P. Bazˇant, ed. Elsevier Applied Science, London, New York, pp. 4–144.
2.
ASTM, 1990, Standards and Literature References for Composite Materials, 2nd ed., American Society for Testing and Materials, Philadelphia.
3.
Bao
G.
,
Ho
S.
,
Suo
Z.
, and
Fan
B.
,
1992
, “
The Role of Material Orthotropy in Fracture Specimens for Composites
,”
Int. J. Solid Structures
, Vol.
29
(
9
), pp.
1105
–
1116
.
4.
Bazˇant
Z. P.
,
1984
, “
Size Effect in Blunt Fracture: Concrete, Rock Metal
.”
J. of Engrg. Mech.
, ASCE, Vol.
110
, pp.
518
–
535
.
5.
Bazˇant
Z. P.
,
Pfeiffer
P. A.
,
1987
, “
Determination of Fracture Energy from Size Effect and Brittleness Number
.”
ACI Materials J.
, Vol.
84
, pp.
463
–
480
.
6.
Bazˇant
Z. P.
, and
Kazemi
M. T.
,
1990
a, “
Determination of Fracture Energy, Process Zone Length and Brittleness Number From Size Effect, With Application to Rock and Concrete
.”
Int. J. of Fracture
, Vol.
44
, pp.
111
–
131
.
7.
Bazˇant
Z. P.
, and
Kazemi
M. T.
,
1990
b, “
Size Effect in Fracture of Ceramics and Its Use to Determine the Fracture Energy and Effective Process Zone Length
,”
J. of American Ceramic Society
, Vol.
73
(
7
), pp.
1841
–
1853
.
8.
Bazˇant
Z. P.
,
Tabbara
M. R.
,
Kazemi
M. T.
, and
Pijaudier-Cabot
G.
,
1990
, “
Random Particle Model for Fracture of Aggregate or Fiber Composites
.”
J. of Engrg. Mechanics, ASCE
, Vol.
116
(
8
), pp.
1686
–
1705
.
9.
Bazˇant
Z. P.
,
Gettu
R.
, and
Kazemi
M. T.
,
1991
a, “
Identification of Nonlinear Fracture Properties From Size Effect Tests and Structural Analysis Based on Geometry-Dependent R-Curves
.”
Int. J. of Rock Mechanics, Mining Science & Geomechanical Abstracts
, Vol.
28
(
1
), pp.
43
–
51
.
10.
Bazˇant
Z. P.
, and
Xi
Y.
,
1991
c, “
Statistical Size Effect in Quasi-Brittle Structures: II. Nonlocal Theory
,”
J. of Engrg. Mech., ASCE
, Vol.
117
(
11
), pp.
2623
–
2640
.
11.
Bazˇant, Z. P., and Cedolin, L., 1991, Stability of Structures: Elastic, Inelastic, Fracture and Damage Theories, Oxford University Press, New York.
12.
Bazˇant
Z. P.
, and
Ozbolt
J.
,
1992
, “
Compression failure of quasi-brittle material: Nonlocal microplane model
.”
J. of Engrg. Mechanics
, ASCE, Vol.
118
(
3
), pp.
540
–
556
.
13.
Bazˇant
Z. P.
, and
Tabbara
M. R.
,
1992
, “
Bifurcation and Stability of Structures with Interacting Propagating Cracks
.”
Int. J. of Fracture
, Vol.
53
, pp.
273
–
289
.
14.
Bazˇant
Z. P.
, and
Jira´sek
M.
,
1995
, “
Particle Model for Quasi Brittle Fracture and Application to Sea Ice
.”
J. of Engrg. Mechanics, ASCE
, Vol.
121
(
9
), pp.
1016
–
1025
.
15.
Bazˇant
Z. P.
,
1993
, “
Scaling Laws in Mechanics of Failure
.”
J. of Engrg. Mech.
ASCE, Vol.
119
(
9
),
1828
–
1844
.
16.
Bazˇant, Z. P., 1995, “Scaling Theories for Quasi-Brittle Fracture: Recent Advances and New Directions,” Proc. 2nd Int. Conf.on Fracture Mechanics of Concrete and Concrete Structures (held at E.T.H., Zu¨rich), F. H. Wittmann, ed. AFICIONADO Publishers, Freiburg, Germany, pp. 515–534.
17.
Cruse
T. A.
,
1973
, “
Tensile Strength of Notched Composites
.”
J. of Composite Materials
, Vol.
7
, pp.
218
–
228
.
18.
Daniel
I. M.
,
1978
, “
Strain and Failure Analysis of Graphite/Epoxy Plate With Cracks
,”
Experimental Mechanics
, Vol.
18
, July, pp.
246
–
252
.
19.
Daniel
I. M.
,
1980
, “
Behavior of Graphite/Epoxy Plates with Holes Under Biaxial Loading
.”
Exper. Mechanics
, Vol.
20
(
1
), pp.
1
–
8
.
20.
Daniel, I. M., 1981, “Biaxial Testing of Graphite/Epoxy Laminates with Cracks,” ASTM STP 734, American Soc. for Testing and Materials, 109–128.
21.
Daniel, I. M., 1982, “Failure Mechanisms and Fracture of Composite Laminates With Stress Concentrations.” VIIth International Conference on Experimental Stress Analysis, Haifa, Israel, Aug. 23-27. pp. 1–20.
22.
Daniel
I. M.
,
1985
, “
Mixed-Mode Failure of Composite Laminates with Cracks
,”
Experimental Mechanics
, Vol.
25
, Dec., pp.
413
–
420
.
23.
Daniel, I. M., and Ishai, O., 1994, Engineering Mechanics of Composite Materials, Oxford University Press, New York.
24.
Jackson
K. E.
,
Kellas
S.
, and
Morton
J.
,
1992
, “
Scale Effects in the Response and Failure of Fiber Reinforced Composite Laminates Loaded in Tension and in Flexure
.”
J. of Composite Materials
, Vol.
26
(
18
), pp.
2674
–
2705
.
25.
Mandell
J. F.
,
Wang
S.-S.
, and
McGarry
F. J.
,
1975
, “
The Extension of Crack Tip Damage Zone in Fiber Reinforced Plastic Laminates
,”
J. of Composite Materials
, Vol.
9
, July, pp.
266
–
287
.
26.
Nallathambi
P.
, and
Karihaloo
B. L.
,
1986
, “
Determination of Specimen-Size Independent Fracture Toughness of Plain Concrete
,”
Mag. of Concrete Res.
, Vol.
38
(
135
), pp.
67
–
76
.
27.
Pijaudier-Cabot
G.
, and
Bazant
Z. P.
,
1991
, “
Crack Interacting with Particles or Fibers in Composite Materials
.”
J. of Engrg. Mech., ASCE
, Vol.
117
(
7
), July, pp.
1611
–
1630
.
28.
Tada, H., Paris, P. C., and Irwin, G. R., 1985, The Stress Analysis of Cracks Handbook, Second Edition, Paris Productions Inc., MO.
29.
Tsai
S. W.
, and
Wu
E. M.
,
1971
, “
A General Theory of Strength For Anisotropic Materials
.”
J. of Composite Materials
, Vol.
5
, January, pp.
58
–
80
.
30.
Waddoups
M. E.
,
Eisenmann
J. R.
, and
Kaminski
B. E.
,
1971
, “
Microscopic Fracture Mechanisms of Advanced Composite Materials
,”
J. of Composite Materials
, Vol.
5
, pp.
446
–
454
.
31.
Whitney
J. M.
, and
Nuismer
R. J.
,
1974
, “
Stress Fracture Criteria for Laminated Composites Containing Stress Concentrations
.”
J. of Composite Materials
, Vol.
8
, July pp.
253
–
264
.
32.
Wisnom
M. R.
,
1992
a, “
The Relationship Between Tensile and Flexural Strength of Unidirectional Composite
.”
J. of Composite Materials
, Vol.
26
(
8
), pp.
1173
–
1180
.
33.
Wisnom
M. R.
,
1992
b, “
On The Increase In Fracture Energy With Thickness in Delamination of Unidirectional Glass Fiber-Epoxy With Cut Central Plies
,”
J. of Reinforced Plastics and Composites
, Vol.
11
(
8
), pp.
897
–
909
.
This content is only available via PDF.
Copyright © 1996
 by The American Society of Mechanical Engineers
You do not currently have access to this content.