Recently, graphite porous material has been used successfully in an aerostatic bearing. In actual bearing design, it is often necessary to reduce the thickness of porous material to make the bearing smaller. However, a reduction in thickness results in a reduction in the strength of the porous material. In particular, when the diameter of porous material is large, it is difficult to supply the air through the full pad area of porous material because it deforms. Therefore, in this paper, two types of air supply method (the annular groove supply and the hole supply) in a circular aerostatic porous thrust bearing are proposed to avoid the deflection of the bearing surface. The static and dynamic characteristics of aerostatic porous bearing with these air supply methods are investigated theoretically and experimentally. In addition, the effects of a surface restricted layer on the characteristics are clarified.
Skip Nav Destination
Article navigation
July 2001
Technical Papers
Static and Dynamic Characteristics of Aerostatic Circular Porous Thrust Bearings (Effect of the Shape of the Air Supply Area)
S. Yoshimoto, Professor,,
S. Yoshimoto, Professor,
Department of Mechanical Engineering, Science University of Tokyo, 1-3 Kagurazaka Shinjuku-ku, Tokyo 162-8601, Japan
Search for other works by this author on:
K. Kohno
K. Kohno
Takara Standard Co. Ltd., 1-2-1 Shigino-higashi Joto-ku, Osaka City 506-0013, Japan
Search for other works by this author on:
S. Yoshimoto, Professor,
Department of Mechanical Engineering, Science University of Tokyo, 1-3 Kagurazaka Shinjuku-ku, Tokyo 162-8601, Japan
K. Kohno
Takara Standard Co. Ltd., 1-2-1 Shigino-higashi Joto-ku, Osaka City 506-0013, Japan
Contributed by the Tribology Division of THE AMERICAN SOCIETY OF MECHANICAL ENGINEERS for presentation at the STLE/ASME Tribology Conference, Seattle, WA, October 1–4. Manuscript received by the Tribology Division February 15, 2000; revised manuscript received June 30, 2000. Paper No. 2000-TRIB-28. Associate Editor: J. Fre^ne.
J. Tribol. Jul 2001, 123(3): 501-508 (8 pages)
Published Online: June 30, 2000
Article history
Received:
February 15, 2000
Revised:
June 30, 2000
Citation
Yoshimoto, S., and Kohno, K. (June 30, 2000). "Static and Dynamic Characteristics of Aerostatic Circular Porous Thrust Bearings (Effect of the Shape of the Air Supply Area) ." ASME. J. Tribol. July 2001; 123(3): 501–508. https://doi.org/10.1115/1.1308027
Download citation file:
Get Email Alerts
Flow Characteristics of Asymmetric Plunger Pairs in High-Pressure Plunger Pumps
J. Tribol (April 2025)
Related Articles
The Effect of Porosity on the Head-Media Interface
J. Tribol (July,2001)
Tribological Study of a Slider Bearing in the Supersonic Regime
J. Tribol (October,2016)
Tribology of Flexible Seals for Reciprocating Motion
J. Tribol (October,2000)
Some Discussions on the Flow Factor Tensor—Considerations of Roughness Orientation and Flow Rheology
J. Tribol (October,2000)
Related Proceedings Papers
Related Chapters
Hydrodynamic Lubrication
Design of Mechanical Bearings in Cardiac Assist Devices
On the Evaluation of Thermal and Mechanical Factors in Low-Speed Sliding
Tribology of Mechanical Systems: A Guide to Present and Future Technologies
Tribology-by-Design for Bearing and Gear Steel Tribology
Bearing and Transmission Steels Technology