The paper presents the results of an X-ray photoelectron spectroscopy (XPS) and X-ray diffraction (XRD) study of chemical and phase composition of the friction surfaces Fe–Mn–C–B–Si–Ni–Cr hardfacing coatings. The alloy was used as a core mixture to produce flux-cored wire of 2.4 mm in diameter. The coating was deposited by gas metal arc welding using CO2 as a shielding gas. The tribological examination was conducted in a ball on disk system with a load of 20 N under dry friction conditions. A XPS were used to examine the structures on the friction surface and depend on depth 5, 10, 15, 20, 50, 100, 200, and 6000 nm. The segregation of C, B, and Si atoms was observed in the process of the friction. The presence of compounds such as oxides (B2O3, SiO2, Cr2O3), carbides (Fe3C, Cr7C3), and borides (FeB, Fe2B) was detected on the surface and in the subsurface layer of the Fe–Mn–C–B–Si–Ni–Cr coating. The formation of these structures increases the wear resistance of composite coatings.
Skip Nav Destination
Article navigation
March 2018
Research-Article
Chemical and Phase Composition of the Friction Surfaces Fe–Mn–C–B–Si–Ni–Cr Hardfacing Coatings
Mykhaylo I. Pashechko,
Mykhaylo I. Pashechko
Fundamentals of Technology Faculty,
Lublin University of Technology,
38 Nadbystrzycka Street,
Lublin 20-618, Poland
e-mail: mpashechko@hotmail.com
Lublin University of Technology,
38 Nadbystrzycka Street,
Lublin 20-618, Poland
e-mail: mpashechko@hotmail.com
Search for other works by this author on:
Krzysztof Dziedzic,
Krzysztof Dziedzic
Electrical Engineering and Computer
Science Faculty,
Institute of Computer Science,
Lublin University of Technology,
36B Nadbystrzycka Street,
Lublin 20-618, Poland
e-mail: k.dziedzic@pollub.pl
Science Faculty,
Institute of Computer Science,
Lublin University of Technology,
36B Nadbystrzycka Street,
Lublin 20-618, Poland
e-mail: k.dziedzic@pollub.pl
Search for other works by this author on:
Ewaryst Mendyk,
Ewaryst Mendyk
Faculty of Chemistry,
Maria Curie-Sklodowska University,
3 Square Maria Curie-Sklodowska,
Lublin 20-031, Poland
e-mail: emendyk@poczta.umcs.lublin.pl
Maria Curie-Sklodowska University,
3 Square Maria Curie-Sklodowska,
Lublin 20-031, Poland
e-mail: emendyk@poczta.umcs.lublin.pl
Search for other works by this author on:
Jerzy Jozwik
Jerzy Jozwik
Mechanical Engineering Faculty,
Lublin University of Technology,
36 Nadbystrzycka Street,
Lublin 20-816, Poland
e-mail: j.jozwik@pollub.pl
Lublin University of Technology,
36 Nadbystrzycka Street,
Lublin 20-816, Poland
e-mail: j.jozwik@pollub.pl
Search for other works by this author on:
Mykhaylo I. Pashechko
Fundamentals of Technology Faculty,
Lublin University of Technology,
38 Nadbystrzycka Street,
Lublin 20-618, Poland
e-mail: mpashechko@hotmail.com
Lublin University of Technology,
38 Nadbystrzycka Street,
Lublin 20-618, Poland
e-mail: mpashechko@hotmail.com
Krzysztof Dziedzic
Electrical Engineering and Computer
Science Faculty,
Institute of Computer Science,
Lublin University of Technology,
36B Nadbystrzycka Street,
Lublin 20-618, Poland
e-mail: k.dziedzic@pollub.pl
Science Faculty,
Institute of Computer Science,
Lublin University of Technology,
36B Nadbystrzycka Street,
Lublin 20-618, Poland
e-mail: k.dziedzic@pollub.pl
Ewaryst Mendyk
Faculty of Chemistry,
Maria Curie-Sklodowska University,
3 Square Maria Curie-Sklodowska,
Lublin 20-031, Poland
e-mail: emendyk@poczta.umcs.lublin.pl
Maria Curie-Sklodowska University,
3 Square Maria Curie-Sklodowska,
Lublin 20-031, Poland
e-mail: emendyk@poczta.umcs.lublin.pl
Jerzy Jozwik
Mechanical Engineering Faculty,
Lublin University of Technology,
36 Nadbystrzycka Street,
Lublin 20-816, Poland
e-mail: j.jozwik@pollub.pl
Lublin University of Technology,
36 Nadbystrzycka Street,
Lublin 20-816, Poland
e-mail: j.jozwik@pollub.pl
1Corresponding author.
Contributed by the Tribology Division of ASME for publication in the JOURNAL OF TRIBOLOGY. Manuscript received December 18, 2016; final manuscript received August 23, 2017; published online October 9, 2017. Assoc. Editor: Dae-Eun Kim.
J. Tribol. Mar 2018, 140(2): 021302 (5 pages)
Published Online: October 9, 2017
Article history
Received:
December 18, 2016
Revised:
August 23, 2017
Citation
Pashechko, M. I., Dziedzic, K., Mendyk, E., and Jozwik, J. (October 9, 2017). "Chemical and Phase Composition of the Friction Surfaces Fe–Mn–C–B–Si–Ni–Cr Hardfacing Coatings." ASME. J. Tribol. March 2018; 140(2): 021302. https://doi.org/10.1115/1.4037953
Download citation file:
Get Email Alerts
Related Articles
An Investigation on Transition Between Mild and Severe Wear in Mg–5Al–0.8Zn Magnesium Alloy Using Recrystallization Kinetics Modeling
J. Tribol (July,2015)
Tribological Study of Fe–W–P Electrodeposited Coating on 316 L Stainless Steel
J. Tribol (January,2018)
High-Temperature Tribology of AA5052/ZrB 2 PAMCs
J. Tribol (January,2017)
Related Proceedings Papers
Related Chapters
Surface Analysis and Tools
Tribology of Mechanical Systems: A Guide to Present and Future Technologies
Simulation of Tribological Performance of Coatings for Automotive Piston Ring and Timing Chain in Bench Testing
Bench Testing of Industrial Fluid Lubrication and Wear Properties Used in Machinery Applications
Contact Laws
Contact in Structural Mechanics: A Weighted Residual Approach