Skip Nav Destination
Issues
January 1980
This article was originally published in
Journal of Lubrication Technology
ISSN 0022-2305
In this Issue
Research Papers
Men of Tribology
J. of Lubrication Tech. January 1980, 102(1): 1–7.
doi: https://doi.org/10.1115/1.3251432
Topics:
Tribology
Thermally Induced Whirl of a Rigid Rotor on Hydrodynamic Journal Bearings
J. of Lubrication Tech. January 1980, 102(1): 8–14.
doi: https://doi.org/10.1115/1.3251445
Topics:
Journal bearings
,
Rotors
,
Whirls
,
Bearings
,
Temperature
,
Lubricants
,
Clearances (Engineering)
,
Pressure
,
Stability
,
Steady state
Some Factors Influencing the Contact Behavior of Surfaces
J. of Lubrication Tech. January 1980, 102(1): 15–17.
doi: https://doi.org/10.1115/1.3251430
Topics:
Deformation
,
Metal surfaces
,
Stress
The Rayleigh Bearing
J. of Lubrication Tech. January 1980, 102(1): 18–27.
doi: https://doi.org/10.1115/1.3251431
Topics:
Bearings
,
Flow (Dynamics)
,
Boundary-value problems
,
Deflection
,
Strips
,
Computers
,
Cutting
,
Die cutting
,
Differential equations
,
Errors
Nonlinear Pad Functions for Static Analysis of Tilting Pad Bearings
J. of Lubrication Tech. January 1980, 102(1): 28–33.
doi: https://doi.org/10.1115/1.3251433
Topics:
Bearings
,
Damping
,
Design
,
Dynamic response
,
Load bearing capacity
,
Manufacturing
,
Numerical analysis
,
Rotors
,
Stiffness
An Analytical Solution for Thermal Behavior of the Step Thrust Bearing
J. of Lubrication Tech. January 1980, 102(1): 34–40.
doi: https://doi.org/10.1115/1.3251434
Topics:
Thrust bearings
,
Energy dissipation
,
Temperature
,
Bearings
,
Computer software
,
Convection
,
Eigenfunctions
,
Eigenvalues
,
Geometry
,
Heat conduction
Pressurized Oil Squeeze Film Dampers
J. of Lubrication Tech. January 1980, 102(1): 41–47.
doi: https://doi.org/10.1115/1.3251435
Topics:
Dampers
,
Bearings
,
Rotors
,
Approximation
,
Clearances (Engineering)
,
Damping
,
Design methodology
,
Pressure
,
Stiffness
Analysis of Squeeze Films Between Curved Annular Plates
J. of Lubrication Tech. January 1980, 102(1): 48–50.
doi: https://doi.org/10.1115/1.3251436
Topics:
Plates (structures)
Nonlinear Response of Short Squeeze Film Dampers
J. of Lubrication Tech. January 1980, 102(1): 51–58.
doi: https://doi.org/10.1115/1.3251438
Topics:
Dampers
,
Transients (Dynamics)
,
Bearings
,
Frequency response
,
Approximation
,
Differential equations
,
Dynamic response
,
Fluids
,
Hardening
,
Rotors
Investigations of Externally Pressurized Gas Bearings With Different Feeding Systems
J. of Lubrication Tech. January 1980, 102(1): 59–64.
doi: https://doi.org/10.1115/1.3251439
Topics:
Bearings
,
Pressurized gas
,
Computational methods
,
Stress
,
Dimensions
,
Energy consumption
,
Geometry
,
Journal bearings
,
Orifices
An Experimental Investigation Into the Rubber-Stabilization of an Externally-Pressurized Air-Lubricated Thrust Bearing
J. of Lubrication Tech. January 1980, 102(1): 65–70.
doi: https://doi.org/10.1115/1.3251440
Topics:
Rubber
,
Thrust bearings
,
Stability
,
Seals
Dynamic and Static Properties of Recessed Hydrostatic Journal Bearings by Small Displacement Analysis
J. of Lubrication Tech. January 1980, 102(1): 71–79.
doi: https://doi.org/10.1115/1.3251441
Topics:
Displacement
,
Hydrostatics
,
Journal bearings
,
Stiffness
,
Bearings
,
Damping
,
Whirls
,
Clearances (Engineering)
,
Design
,
Flow control
A Factored Implicit Scheme for the Numerical Solution of the Reynolds Equation at Very Low Spacing
J. of Lubrication Tech. January 1980, 102(1): 80–85.
doi: https://doi.org/10.1115/1.3251442
Topics:
Algorithms
,
Computation
,
Flow (Dynamics)
,
Lubricants
,
Magnetic recording
,
Resolution (Optics)
Analysis of the Flexible Disk/Head Interface
J. of Lubrication Tech. January 1980, 102(1): 86–90.
doi: https://doi.org/10.1115/1.3251444
Topics:
Disks
,
Deflection
,
Air bearings
,
Pressure
,
Stiffness
The Influence of Surface Tension on Bearings Lubricated With Bubbly Liquids
J. of Lubrication Tech. January 1980, 102(1): 91–96.
doi: https://doi.org/10.1115/1.3251446
Topics:
Bearings
,
Surface tension
,
Bubbles
,
Equations of motion
,
Failure
,
Fuel gasification
,
Inertia (Mechanics)
,
Load bearing capacity
,
Lubricants
,
Lubrication
Load Support System Analysis-High Speed Input Pinion Configuration
J. of Lubrication Tech. January 1980, 102(1): 97–106.
doi: https://doi.org/10.1115/1.3251447
Topics:
Stress
,
Bearings
,
Design
,
Gears
,
Lubrication
,
Cantilevers
,
Computer software
,
Deformation
,
Displacement
,
Friction
Friction, Wear, and Temperature in Sliding Contact
J. of Lubrication Tech. January 1980, 102(1): 107–112.
doi: https://doi.org/10.1115/1.3251426
Topics:
Friction
,
Temperature
,
Wear
,
Machinery
,
Heating
,
Simulation
,
Spur gears
,
Stress
Externally Pressurized Gas Journal Bearings With Porous Inserts
J. of Lubrication Tech. January 1980, 102(1): 113–116.
doi: https://doi.org/10.1115/1.3251427
Topics:
Journal bearings
,
Pressurized gas
Awards
The Burt L. Newkirk Award Presented to Thomas A. Dow
J. of Lubrication Tech. January 1980, 102(1): 50.
doi: https://doi.org/10.1115/1.3251437
Technical Briefs
A Note on the Optimum Design of Slider Bearings
J. of Lubrication Tech. January 1980, 102(1): 117–119.
doi: https://doi.org/10.1115/1.3251428
Topics:
Design
,
Slider bearings
Thermal Convection in Short-Bearing Films
J. of Lubrication Tech. January 1980, 102(1): 119–123.
doi: https://doi.org/10.1115/1.3251429
Topics:
Bearings
,
Convection
,
Heat conduction
,
Temperature distribution