Local mass transfer measurements on a simulated high-pressure turbine blade are conducted in a linear cascade with tip clearance, using a naphthalene sublimation technique. The effects of tip clearance (0.86–6.90% of chord) are investigated at an exit Reynolds number of and a low turbulence intensity of 0.2%. The effects of the exit Reynolds number and the turbulence intensity (0.2 and 12.0%) are also measured for the smallest tip clearance. The effect of tip clearance on the mass transfer on the pressure surface is limited to 10% of the blade height from the tip at smaller tip clearances. At the largest tip clearance high mass transfer rates are induced at 15% of curvilinear distance by the strong acceleration of the fluid on the pressure side into the clearance. The effect of tip clearance on the mass transfer is not very evident on the suction surface for curvilinear distance of However, much higher mass transfer rates are caused downstream of by the tip leakage vortex at the smallest tip clearance, while at the largest tip clearance, the average mass transfer is lower than that with zero tip clearance, probably because the strong leakage vortex pushes the passage vortex away from the suction surface. High mainstream turbulence level (12.0%) increases the local mass transfer rates on the pressure surface, while a higher mainstream Reynolds number generates higher local mass transfer rates on both near-tip surfaces.
Skip Nav Destination
Article navigation
July 2003
Technical Papers
Local Mass/Heat Transfer on Turbine Blade Near-Tip Surfaces
P. Jin,
P. Jin
Heat Transfer Laboratory, Department of Mechanical Engineering, University of Minnesota, Minneapolis, MN 55455
Search for other works by this author on:
R. J. Goldstein
R. J. Goldstein
Heat Transfer Laboratory, Department of Mechanical Engineering, University of Minnesota, Minneapolis, MN 55455
Search for other works by this author on:
P. Jin
Heat Transfer Laboratory, Department of Mechanical Engineering, University of Minnesota, Minneapolis, MN 55455
R. J. Goldstein
Heat Transfer Laboratory, Department of Mechanical Engineering, University of Minnesota, Minneapolis, MN 55455
Contributed by the International Gas Turbine Institute and presented at the International Gas Turbine and Aeroengine Congress and Exhibition, Amsterdam, The Netherlands, June 3–6, 2002. Manuscript received by the IGTI October 10, 2001. Paper No. 2002-GT-30556. Review Chair: E. Benvenuti.
J. Turbomach. Jul 2003, 125(3): 521-528 (8 pages)
Published Online: August 27, 2003
Article history
Received:
October 10, 2001
Online:
August 27, 2003
Citation
Jin , P., and Goldstein, R. J. (August 27, 2003). "Local Mass/Heat Transfer on Turbine Blade Near-Tip Surfaces ." ASME. J. Turbomach. July 2003; 125(3): 521–528. https://doi.org/10.1115/1.1554410
Download citation file:
Get Email Alerts
Related Articles
Influence of Blade Leading Edge Geometry on Turbine Endwall Heat (Mass) Transfer
J. Turbomach (October,2006)
Effect of Endwall Motion on Blade Tip Heat Transfer
J. Turbomach (April,2003)
Turbulent Transport on the Endwall in the Region Between Adjacent Turbine Blades
J. Heat Transfer (November,1988)
Separated Flow Transition on an LP Turbine Blade With Pulsed Flow Control
J. Turbomach (April,2008)
Related Chapters
Cavitating Structures at Inception in Turbulent Shear Flow
Proceedings of the 10th International Symposium on Cavitation (CAV2018)
Laminar Fluid Flow and Heat Transfer
Applications of Mathematical Heat Transfer and Fluid Flow Models in Engineering and Medicine
Baking Pizza by Infrared Radiation and Conduction Heat Transfers and Mass Transfer in Unsteady State
Electromagnetic Waves and Heat Transfer: Sensitivites to Governing Variables in Everyday Life