Boundary layer measurements have been made on the concave surfaces of two constant curvature blades using hot wire anemometry. All the current experiments were performed with negligible streamwise pressure gradient. Grids were used to produce a range of freestream turbulence levels between 1% and 4%. The freestream velocity increases with distance from a concave wall according to the free vortex condition making the determination of the boundary layer edge difficult. A flat plate equivalent boundary layer procedure was adopted, therefore, to overcome this problem. The Taylor–Goertler (TG) vortices resulting from the concave curvature were found to make the laminar and turbulent boundary layer profiles fuller and to increase the skin friction coeffiicent by up to 40% compared with flat plate values. This leads to a more rapid growth in boundary layer thickness. The evolution in the intermittency through transition is very similar to that for a flat plate, however, the shape factors are depressed slightly throughout the flow due to the fuller velocity profiles. For all the current experiments, curvature promoted transition. This was very marked at low freestream turbulence level but remained significant even at the highest levels. It appears that the velocity fluctuations associated with the TG vortices enhance the freestream turbulence resulting in a higher effective turbulence level. A new empirical correlation for start of transition based on this premise is presented. The ratio of end to start of transition momentum thickness Reynolds numbers was found to be approximately constant.
Skip Nav Destination
Article navigation
July 2005
Technical Papers
Transition on Concave Surfaces
Antonis Dris,
Antonis Dris
Department of Engineering,
University of Liverpool
, Liverpool L69 3GH, UK
Search for other works by this author on:
Mark W. Johnson
Mark W. Johnson
Department of Engineering,
University of Liverpool
, Liverpool L69 3GH, UK
Search for other works by this author on:
Antonis Dris
Department of Engineering,
University of Liverpool
, Liverpool L69 3GH, UK
Mark W. Johnson
Department of Engineering,
University of Liverpool
, Liverpool L69 3GH, UKJ. Turbomach. Jul 2005, 127(3): 507-511 (5 pages)
Published Online: March 1, 2004
Article history
Received:
October 1, 2003
Revised:
March 1, 2004
Citation
Dris, A., and Johnson, M. W. (March 1, 2004). "Transition on Concave Surfaces." ASME. J. Turbomach. July 2005; 127(3): 507–511. https://doi.org/10.1115/1.1861914
Download citation file:
Get Email Alerts
Cited By
Evaluating Thin-Film Thermocouple Performance on Additively Manufactured Turbine Airfoils
J. Turbomach (July 2025)
Thermohydraulic Performance and Flow Structures of Diamond Pyramid Arrays
J. Turbomach (July 2025)
Related Articles
Predicting Transition on Concave Surfaces
J. Turbomach (October,2007)
Development of Taylor-Go¨rtler Vortices Over the Pressure Surface of a Turbine Blade
J. Heat Transfer (May,2005)
Large-Eddy Simulation of Unsteady Surface Pressure Over a Low-Pressure Turbine Blade due to Interactions of Passing Wakes and Inflexional Boundary Layer
J. Turbomach (April,2006)
Endwall Boundary Layer Development in an Engine Representative Four-Stage Low Pressure Turbine Rig
J. Turbomach (January,2009)
Related Chapters
Introduction
Design and Analysis of Centrifugal Compressors
Cavitating Structures at Inception in Turbulent Shear Flow
Proceedings of the 10th International Symposium on Cavitation (CAV2018)
Boundary Layer Analysis
Centrifugal Compressors: A Strategy for Aerodynamic Design and Analysis