Motivated by the recent advances in additive manufacturing, a novel turbine end-wall aerothermal management method is presented in this two-part paper. The feasibility of enhancing purge air cooling effectiveness through engineered surface structure was experimentally and numerically investigated. The fundamental working mechanism and improved cooling performance for a 90 deg turning duct are presented in Part I. The second part of this paper demonstrates this novel concept in a low-speed linear cascade environment. The performance in three purge air blowing ratios is presented and enhanced cooling effectiveness and net heat flux reduction (NHFR) were observed from experimental data, especially for higher blow ratios. The Computational fluid dynamics (CFD) analysis indicates that the additional surface features are effective in reducing the passage vortex and providing a larger area of coolant coverage without introducing additional aerodynamic loss.
Improving Purge Air Cooling Effectiveness by Engineered End-Wall Surface Structures—Part II: Turbine Cascade
Contributed by the International Gas Turbine Institute (IGTI) of ASME for publication in the JOURNAL OF TURBOMACHINERY. Manuscript received January 31, 2018; final manuscript received July 11, 2018; published online August 20, 2018. Assoc. Editor: David G. Bogard.
- Views Icon Views
- Share Icon Share
- Search Site
Miao, X., Zhang, Q., Atkin, C., Sun, Z., and Li, Y. (August 20, 2018). "Improving Purge Air Cooling Effectiveness by Engineered End-Wall Surface Structures—Part II: Turbine Cascade." ASME. J. Turbomach. September 2018; 140(9): 091002. https://doi.org/10.1115/1.4040854
Download citation file:
- Ris (Zotero)
- Reference Manager